Dryer Description; The Features; Control Panel; The Controls - Hotpoint TCEL 87C Instruction Booklet

Dryer Description

The features

Filter
Condenser cover

Control panel

The ON/OFF button : If the dryer is running and
this button is pressed and held for more that 3 seconds
the dryer is turned off, the programme is then cancelled.
Press and hold for more than 3 seconds and the dryer
reactivates.
The PROGRAMMES knob sets the programme: rotate
it until the indicator is pointing to the programme you want
to select or to Timed Drying (see Start and Programmes).
Use the DRYING LEVELS knob to set your required
dryness sensing level, or the TIMER DRYING knob to
select a drying time (see Start and Programmes).
The OPTION buttons/lights select available options for
your selected programme. The lights indicate that the
option has been selected (see Start and Programmes).
The START/PAUSE button/light
programme. When you press this button there will be
one beep and the progress lights will flash to confirm
the action. When a programme is running, pressing this
button in pauses the programme and stops the dryer.
The light is green when programme is running, flashing
amber if the programme has been paused or flashing
green if on standby waiting to start a programme (see
Start and Programmes).
Note: This light also flashes amber during the Post
Care phase of a programme.
Water container
Rating plate
DRYING LEVELS
PROGRAMMES
Indicator
Knob
ON/OFF
Buttons & Lights
Button
starts a selected
Model & Serial numbers
Condenser cover handle
(Pull to open)
Air intake grille
TIMER
DRYING
Knob Empty Water
Knob
OPTION START/PAUSE
Button & Light
The Progress or Delay lights show you the status of
the programme, or the delay time when they flash.
During a delayed start the lights flash to show the
delay selected. When (not flashing) they show each
stage of the programme by the corresponding light
turning on (see Start and Programmes).
The Empty Water indicator light signals that the water
container should be emptied. The light will take a few
seconds to go out after replacing the empty water
container, the dryer must be running for this to happen
(see The Controls).
Note: If the water bottle fills the indicator light flashes, the
heat is turned off and your clothes will not dry.
The Clean Filter light gives you a reminder before
every programme that it is essential to clean the filter
every time the dryer is used (see Maintenance and Care).
The Clean Condenser light gives you a reminder that
it is essential to clean the condenser at regular intervals
(see Maintenance and Care).
Clean Filter
Light
Clean Condenser
Light
Light
Progress or Delay
Lights
7
GB