Duratrax Evader EXT2 Assembly And Operation Manual page 5

6-CELL BATTERY INSTALLATION
• Install the charged 6-cell battery
into the battery slot. Re-install the
battery strap and the clip into the
battery strap post.
• If you use a 7-cell battery, remove
the foam battery spacer block under
the ESC.
RADIO SYSTEM CHECK
• Turn on the transmitter. Then turn on the receiver.
(Always turn on the transmitter fi rst!)
• Turn the transmitter wheel to the right—the front
wheels should turn to the right. If not, move the
steering servo reverse switch.
• When running, adjust the steering trim so the
truck tracks straight.
• Charge the 6-cell battery (not included) on the charger
(not included). See Safety Precautions before
charging. Charge the battery according to the
instructions that came with your charger.
• Remove the clip from the battery strap post and
remove the battery strap from the Evader EXT2.
Clip
Steering
Servo
Reverse
Switch
On/Off
Throttle
Servo
Reverse
Switch
5 5
Battery
Strap Post
!
ALWAYS CHECK THE RADIO
OPERATION BEFORE EACH RUN
Steering
Trim
Reverse
Forward
Throttle
Trim