Using Rf651 With The Usb Bluetooth Adapter; Preparing The Rf651 For Connection Without A Port Router; Preparing The Rf651 For Connection With A Port Router - Nordic ID RF651 User Manual

���������������
In order to create a connection with the selected Access Server, the user must select the Access Server from the "Device
list". After selecting the <Connect> choice and pressing the <OK> button, the Hand Terminal will try to establish a
connection with the Access Server. This typically takes approximately 5 seconds.
While connecting, the message below will be displayed:
Status message appears in bottom of the display while connecting.
If the connection cannot be established with the Access Server, try again by selecting <Connect> and pressing the
<OK> button.
After successful connection, the Hand Terminal is ready for communicating with the Host Application. Initial screen
appears and the user can start to use the Host Application by pressing <OK> or any <F> key for sending data to the Host
Application for the first time. Usually the Host Application returns a user interface screen for using the actual business
application. If batteries are taken off and placed back again, the Hand Terminal resets first and then connects to the latest
connected device automatically.
3.3

Using RF651 with the USB Bluetooth Adapter

This section describes how to create the Bluetooth connection with the USB adapter (Dongle). It is assumed that all
configurations and settings are already made on the Dongle and Host Application side.
The RF651 Hand Terminal (HT) can communicate via a Bluetooth USB adapter (Dongle). In order to use more than one
RF651 device via a single Dongle, the Nordic ID Port Router software must be used.
The Nordic ID Port Router software allows a maximum of seven simultaneous Bluetooth connections via single Dongle.
If not using Port Router, only one RF651 Hand Terminal at a time can be used with the Dongle.
3.4

Preparing the RF651 for connection without a Port Router

• Set Channel to 0
• Set proper PIN code
• Search and add Dongle Name (PC name) and Bluetooth address to the device list.
• Choose Dongle from the device list for connection, select <Connect> and press <OK>.
3.5

Preparing the RF651 for connection with a Port Router

• Set Channel 5
• Set proper PIN code
• Select <Wait connection>, press <OK> and establish a connection from PortRouter.
(see Port Router manual for detailed information)
© 2006 Nordic ID oy
RF651 User Manual
Fig. Initial screen of the RF651 when the device is connected
Version 1 June 2006
14