Table of Contents
Advertisement
9
• Slide a pedal on the pedal axle. Tap the pedal with a
hammer until it is secure.
• Pull the pedal up to be sure it is secure. If you can
remove it, you have not secured it properly. Tap it with
the hammer again.
• Repeat this procedure to attach the other pedal to the
other end of the pedal axle.
Fork Cover
10
Pedal Axle
• Place the front wheel assembly between the fork arms.
Make sure the pedal axle fits into the groove at the bottom
of each fork arm.
• Place a fork cover over the pedal axle on one fork arm.
• Insert two #10 x
3
/
" screws into the fork cover and tighten.
4
• Repeat this procedure to attach the other fork cover to the
other fork arm, using the #10 x
Assembly
Assembly
Pedal
Pedal Axle
Front Wheel
Assembly
Scrap Block
of Wood
Fork Arms
Groove
3
/
" screws.
4
Fork Covers
11
• Turn the frame upright.
• Insert the fork post up through the hole in
the frame neck. Make sure the fork is
positioned so that the fork covers face
the rear wheels.
• Place the electronic handlebar over the fork
post and push it down onto
the frame. Make sure the
handlebar is positioned so
that the screw hole faces
the rear wheels and aligns
with the screw hole in the
fork post.
• Insert the #8 x 4" screw
through the hole in the
handlebar and into the fork
post so that part of the
screw (about
3
/
") is still
4
visible. Tighten the screw.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052, U.S.A.
©2003 Mattel, Inc. All Rights Reserved.
® and
TM
designate U.S. trademarks of Mattel, Inc.
Printed in Mexico
6
6
Electronic
Handlebar
Frame Neck
Fork
Post
FIRST, insert the screw
3
/
"
so that
is visible.
4
THEN, tighten the screw.
3 /
"
4
B2488pr-0920
Advertisement
Table of Contents
