Image Advanced 1400 IMTL07905.1 User Manual page 12

The left side of the dis-
play will show the incline
level of the treadmill, the
elapsed time, the ap-
proximate number of
grams of carbs you have
burned, and the distance that you have walked or
run. Note: Each time the incline changes, the dis-
play will show the incline setting for a few sec-
onds. When a program is selected, the display will
show the time remaining in the program instead of
the elapsed time.
The right side of the
display will show the
speed of the walking
belt, the approximate
number of calories you
have burned, and your
pace (in minutes per mile). The display will also
show your heart rate when you use the handgrip
pulse sensor or the optional chest pulse sensor.
Note: The console can
display speed and dis-
tance in either miles or
kilometres. The word
"Metric" will appear in
the display when speed
and distance are shown in kilometres. To change
the unit of measurement, first hold down the Stop
button while inserting the key into the console. An
"E" for English miles or an "M" for metric kilometres
will appear in the right side of the display. Press
the Speed + button to change the unit of measure-
ment. When the desired unit of measurement is
selected, remove the key and then reinsert it.
Note: For simplicity, all instructions in this sec-
tion refer to miles.
To reset the display, press the Stop button, re-
move the key, and then reinsert the key.
Measure your heart rate if desired.
6
Note: If you use the handgrip pulse sensor and
the optional chest pulse sensor at the same time,
the console will not display your heart rate accu-
rately. Before
using the hand-
grip pulse sen-
sor, make sure
that your hands
are clean. If
there are sheets
of clear plastic
on the metal con-
tacts on the handgrip pulse sensor, peel off the
plastic.
To measure your heart rate, stand on the foot
rails and hold the metal contacts—avoid moving
your hands. When your pulse is detected, the
heart symbol in the right side of the display will ap-
pear, one or two dashes will appear, and then
your heart rate will be shown. For the most accu-
rate heart rate reading, continue to hold the
contacts for about 15 seconds.
Turn on the fan if desired.
7
To turn on the fan, press the button beside the
Program Select button. To turn on the fan at high
speed, press the button a second time. To turn off
the fan, press the button a third time. Note: A few
minutes after the walking belt is stopped, the fan
will automatically turn off.
When you are finished exercising, remove the
8
key.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
when the treadmill is folded to the storage posi-
tion or the treadmill will be damaged. Next, re-
move the key from the console and put it in a se-
cure place. Note: If the display remains lit after
the key is removed, the console is in the
"demo" mode. See page 23 and turn off the
demo mode.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the off position and
unplug the power cord.
12
Contacts