Do you have a question about the H100ID1 and is the answer not in the manual?
Questions and answers
DAVID GEROFSKY
June 2, 2025
heater not firing
1 comments:
Mr. Anderson
June 2, 2025
The Hayward H100ID1 heater is not firing due to possible issues with the gas valve or the control module circuit board. One case involved a faulty gas valve that was either not receiving power or not operating properly, despite the igniter buzzing, which indicated safety checks were passed. Another issue mentioned cracks in the solder of the edge connector on the control module circuit board, causing the heater to stop heating while the fan kept running.
Page 1
H-Series INDUCED DRAFT HEATERS FOR ABOVE-GROUND POOLS & SPAS Come On In! The Water Is Great! Total System: Pumps I Filters I Heating I Cleaners I Sanitization I Automation I Lighting I Safety...
Page 2
From early morning to late evening. The Hayward H-Series heater for your above-ground pool is one of the best investments you will ever make. Plus, the H-Series heater is made exclusively by Hayward Pool Products, manufacturer of above-ground pool equipment.
Page 3
100,000 BTU input Jet-ported burners for above-ground provide long life pools and spas of all and easy types and sizes. maintenance. 81% thermal One piece efficiency copper header/ gets the heat exchanger most heat for leak-free out of performance. each BTU. Cool-to-the- Induced draft touch cabinet...
Page 4
A solar blanket will reduce your gas costs and keep your pool warmer — longer! Consult your local pool professional. To take a closer look at Hayward Heaters, go to www.haywardnet.com or call 1-888-HAYWARD 620 Division Street I Elizabeth, NJ 07201 Hayward and FireTile are registered trademarks of Hayward Industries, Inc.
Need help?
Do you have a question about the H100ID1 and is the answer not in the manual?
Questions and answers
heater not firing
The Hayward H100ID1 heater is not firing due to possible issues with the gas valve or the control module circuit board. One case involved a faulty gas valve that was either not receiving power or not operating properly, despite the igniter buzzing, which indicated safety checks were passed. Another issue mentioned cracks in the solder of the edge connector on the control module circuit board, causing the heater to stop heating while the fan kept running.
This answer is automatically generated