Hayward ABG1001 Installation, Operation & Service Procedures

Hayward ABG1001 Installation, Operation & Service Procedures

Above ground pool heater

Advertisement

HAYWARD
Installation, Operation & Service Procedures
Above Ground Pool Heater
Unit must be installed outdoors only
and below an altitude of 2000 feet
PATENT US6082993
Models H100ID1 & ABG1001
– Do not store or use gasoline or other flammable vapors or liq-
uids in the vicinity of this or any other appliance.
– Installation and service must be performed by
a qualified installer, service agency or the gas
supplier.
FOR YOUR SAFETY
WARNING: If the information in these instruc-
tions is not followed exactly, a fire or explo-
sion may result causing property damage,
personal injury, or death.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance
Do not touch any electrical switch; do not
use any phone in your building
Immediately call your gas supplier from a
neighbor's phone. Follow the gas suppli-
er's instructions.
If you cannot reach your gas supplier, call
the fire department.
SpaDepot.com
®
1302507301 0607

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ABG1001 and is the answer not in the manual?

Questions and answers

Summary of Contents for Hayward ABG1001

  • Page 1 Installation, Operation & Service Procedures Above Ground Pool Heater Models H100ID1 & ABG1001 Unit must be installed outdoors only and below an altitude of 2000 feet PATENT US6082993 FOR YOUR SAFETY WARNING: If the information in these instruc- tions is not followed exactly, a fire or explo- sion may result causing property damage, personal injury, or death.
  • Page 2: Water Piping

    Section I. General Information Important notice: The instructions herein are intended for the use of a qualified technician, specifically trained and experienced in the installation of this type of heating equipment. Some states or provinces require that installation and service per - sonnel performing the installation be licensed.
  • Page 3 1. Clean filter thoroughly. 2. Set heater thermostat to highest setting. 3. Start filter pump. Make sure all air is out of water lines and complete system is full of water . 4. Place a 5/64” allen head wrench in the adjusting socket on the front of the switch and turn it Section IV.
  • Page 4 Follow local (as codes for proper gas line material selection (copper, iron or plastic etc.) LOW PRESSURE NATURAL GAS PIPE SIZING: (Based upon gas pressure of 0.5 psig or less and a pressure drop of 0.5” W.C.) Distance from Meter (Natural Gas) 0 to25 feet 25 to 100 feet...
  • Page 5: Heater Operation

    Heater operation: Full lighting and shutdown instructions are included on the light - ing instructions label installed on the front access door inside the heater cabinet. This heater cannot be operated with the front door removed. WARNING: If you smell gas in the appliance area or near the floor, stop and follow instructions on the front cover of this manual.
  • Page 6 Operating Instructions Figure 6...
  • Page 7: Parts List

    Parts List & Illustration ITEM NO. DESCRIPTION Jacket, Top Combustion Blower (Jakel Jakel) Combustion Blower (Jakel Fasco conversion) IDX BWR 1931 Combustion Blower (Fasco Fasco) Blower Gasket (Jakel only) High Limit Kit Heat Exchanger Assembly (dual tubes) Heat Exchanger Assembly (single tube after 6/99) Water Pressure Switch Interlock Switch Control Module...
  • Page 8 Hayward Pool Heater Certificate of Limited Warranty Limited heater warranty: TERMS AND COVERAGE: We warrant our pool heater to be free from defects in workmanship and materials under normal use and service. Pursuant to this warranty and subject to the Conditions and Exceptions indi - cated below: 1.

This manual is also suitable for:

H100id1

Table of Contents

Save PDF