Control Panel; Control Panel Assembly - GE Profile PB920TPWW Technical Service Manual

Control Panel

The controls for the oven system consist of a key
panel touch fi lm on glass assembly and a main logic
board with its model select resistor plug located in
the control panel.
The controls for the cooktop elements consist of
two burner touch boards connected to and working
through the main logic board.
The main logic board is connected via the LIN serial
wire to the Relay Power Supply Board (RPSM Main)
located on the back of the range, along with a
second relay board (RPSM Aux).
There is also an RTD oven sensor and motor door
lock assembly with position switches.
Cooktop elements are controlled by relays found
exclusively on the RPSM Aux Board. (See
.)
Diagram
No relay boards or line voltages are brought to the
control panel.
To remove the control panel:
1. Pull the range out approximately 6 inches from
the wall.
2. Remove the six 1/4-in. hex-head screws that
hold the top of the rear panel to the range.
3. Remove the ground screw.
Ground Screw
Rear View

Control Panel Assembly

4. Place a protective cover on the main top of the
5. Using a stubby or offset Phillips-head
6. Grasp the control panel and pull the bottom out,
7. Place the control panel in the service position.
Wiring
– 19 –
oven.
screwdriver, remove the 2 inverted screws that
attach the bottom of the control panel to the
range.
then lift the panel off the top 2 screws.
Service Position