Assembly - Minelab GPX-4000 Quick Start Manual

8

Assembly

1 Plug the two rubber washers into the holes on
2 Ensure that the spring loaded pin of the lower
3 Insert the bolt through the lower shaft and the
Attaching the Coil to the Lower Shaft:
either side of the lower shaft.
shaft is pointing downwards. Slide the lower shaft
into the bracket on top of the coil.
bracket on top of the coil. Fasten with the nut
provided, being careful not to damage the thread
of the nut by over-tightening. This may need to
be loosened to adjust the coil to a comfortable
detecting angle.
The coil cable is directly wired into the coil and is not
removable. Any attempt to disconnect this cable will
void your warranty.
If the coil becomes loose over time, the rubber
washers may need to be replaced.
spring loaded pin
Attaching the Lower Shaft to the Upper Shaft:
1 Rotate the twistlock of the upper shaft counter-
clockwise to ensure that it is loosened.
2 Compress the spring loaded pin of the lower shaft.
Slide the lower shaft into the upper shaft until
the pin reaches an adjustment hole. The pin will
spring out and clip into place.
Attaching the Handle to the Upper Shaft:
1 Slide the bungy cord clamp onto the upper shaft.
2 Slide the handle onto the upper shaft so that it
slopes away from you.
Attaching the Armrest to the Upper Shaft:
1 Place the two armrest halves on either side of the
upper shaft, aligning the armrest and upper shaft
holes.
2 Insert the bolts through the armrest and upper
shaft holes.
3 Loosely fasten the wing-nuts onto the bolts (these
will be tightened after the control box is attached).
9