Installation; Warranty - Kidco BR200 User Manual

Installation

10. To achieve correct strap length, take assem-
bled bed rail frame and place on top of bare mat-
tress so that corner brackets (F) are facing down.
Stretch straps across mattress so that L-bracket
is on opposite mattress edge.
11. Place L-bracket facing down on edge of
mattress and adjust strap length to mattress
width. Pull strap tight. The entire unit should fit
snugly against mattress. Lift off bed rail frame and
remove mattress from bed.
NOTE-Standard Beds: Leave box spring in bed
frame.
NOTE-Platform Beds: Slats or solid board will
now be exposed.
12.1-Standard Beds: (a) Place upright bed rail
frame on top of box spring with corner
brackets and L-bracket facing up. (b) Lower mat-
tress on top of bed rail frame. Corner brackets
and L-bracket should be exposed and tight
against mattress. Pull strap to tighten further.

Warranty

Your KidCo product is warranted to be free from manufacturing defects for a period of one (1) year
from date of purchase under normal, non-commercial use and in compliance with the operating
instructions. This warranty extends only to the original retail purchaser and is only valid when
supplied with proof of purchase. KidCo will either repair, or at our option replace, free of charge, any
parts necessary to correct defects in material or workmanship during the warranty period. This war-
ranty is complete and exclusive. The warranty expressly disclaims liability for incidental, special and
consequential damages of any nature. Any implied warranty arising by operation of law shall be lim-
ited in operation to the terms of this warranty. Some states do not allow the exclusion or limitation
of incidental or consequential damages or limitations on how long an implied warranty lasts, so the
above may not apply to you. This warranty gives you specific legal rights, and you may have other
rights which vary from state to state.
Should a repair be needed during the warranty period, ship the bed rail in the original carton or
similar protective container (check any retail store or purchase from UPS) and send freight prepaid
to: KidCo, Inc. 1013 Technology Way, Libertyville, IL 60048. Include a note with your return address,
day-time telephone number and specify what is wrong with the product. Repairs can normally be
made within 48 hours after receipt at KidCo. The KidCo repair department reserves the right to
make the final determination as to whether the returned item is covered under the limited warranty.
For additional information call our customer service department at (800) 553-5529.
4
When properly tightened, fingers will not fit
between lower part of L-bracket and mattress.
12.2-Platform Beds: (a) Place upright bed rail
frame on top of board or slats (if on slats
L-bracket must be aligned directly on top of
one slat) with corner brackets and L-bracket
facing up. (b) Lower mattress on top of bed rail
frame. Corner brackets and L-bracket should be
exposed and tight against mattress but inside
bed frame. Pull strap to tighten further, lifting
mattress if necessary. When properly tight-
ened, fingers will not fit between lower part of
L-bracket and mattress.
13. Slide ends of bed rail (H) into corner
brackets until a click is heard.
14. Complete bed rail is now installed.
15. To remove, simply press bed rail finger tabs
in and lift rail out of corner brackets. Bed rail
frame stays in place for future use.