Table of Contents
Advertisement
Available languages
Available languages
Important Information
FOLLOW THESE
ENG
INSTRUCTIONS
CAREFULLY AND
KEEP THEM FOR
FUTURE
REFERENCE
WARNING
•
Suffocation and Strangulation Hazard.
•
Death or Serious Injury Can Occur.
•
Infants who cannot get in and out of an
adult bed without help can be trapped
between a mattress and a wall and suf-
focate.
•
NEVER place infants in adult beds with
or without a bed rail.
•
BED RAIL USE: Bed rail can trap
young children against mattress, head-
board or footboard.
•
Use only for children who have out-
grown a crib.
•
NEVER use in place of a crib.
Maintenance
•
No part of the bed rail requires lubrication.
•
Clean using warm soapy water, or a damp
cloth.
Assembly
1. Assemble back bar (A) by pushing tapered end
of one piece into other piece until pin pops up
and 'click' is heard.
2. Insert side bars (B) with pins facing up, into
assembled back bar (A).
3. Slide rail brace (C) onto one end of front bar (D).
4.a Assemble front bar (D) by pushing tapered
end of one piece into other piece until pin pops
up and 'click' is heard.
4.b Slide rail brace over joint until pin pops up
and 'click' is heard.
5. Slide closed end of corner brackets on strap
set (E) onto ends of front bar (D). Keep sliding
until a click is heard.
6. Slide side bars (B) into empty corner bracket
•
Typically for children 2 years and up
•
For use on platform beds and mattress/box
spring beds
•
Use only original KidCo spare parts
•
Use only with children who can get in
and out of adult bed without help (typi-
cally 2 years and up).
•
ALWAYS keep bed rail pushed firmly
against mattress and at least 9 inches
from headboard and footboard.
•
NEVER use on toddler bed, bunk bed,
water bed, or bed with inflatable mat-
tress.
•
Use only on adult bed with mattress
and mattress support as defined by the
manufacturer.
•
Discontinue use if any bed rail parts are
damaged or missing.
•
Do not use abrasive cleaners or bleach.
of strap set (E) using second set of pins. Ends
of side bars (a) and one pin will be sticking out.
When laid out flat, V-strap and buckle are facing
back bar (A).
7. Slide corner brackets (F) onto ends of side
bars (B) until a click is heard. Finger tabs will be
parallel with front bar (D).
8. Slide extension (G) onto L-bracket of strap set,
until a click is heard.
9. Assemble two halves of bed rail (H) by
sliding one connector (I) on both top and bottom
sides of rail; slide in other half of bed rail. Using
screws and screw sockets (J) secure connectors
tightly to bed rail.
3
Advertisement
Table of Contents
