Replying With A Message To An Incoming Message - NEC M155 User Manual

Messaging
With a voice call – this is only possible when the message contains
a call back number. The call back number is identified in the
message by <<xxxx>>, where xxxx is an existing telephone number
and is the destination of the voice call.

Replying with a message to an incoming message

To read an incoming message and reply with a message to the sender,
perform the following steps:
[
[
36
1. The new message is displayed upon receipt.
If the message is too large to show on the
]
display in one go, use (repeatedly) pressing
the Upper key for a short time to scroll
through the message.
2. Simultaneously press both keys for a short
time.
Urgent and Emergency messages are given
a receipt confirmation.
3. Repeatedly press the Upper key for a short
time until the display shows: the message
you want to send.
4. Press the Lower key for a short time.
The message is displayed. If so required use
]
(repeatedly) pressing the Upper key for a
short time to scroll through the message.
5. Press the Lower key for a short time.
6. While sending the message the display
shows Sending.
7. When the message is successfully sent
sent is displayed.
Msg.