Aligning The Fence - Skil 3310 Operating Instructions Manual

Checking and Adjusting the Basic
Adjustment
u Before any work on the machine itself, pull the
mains plug.
To ensure precise cuts, the basic adjustment of
the machine must be checked and adjusted as
necessary after intensive use.
A certain level of experience and appropriate
specialty tools are required for this.
Aligning the Angle Indicator (Horizontally1
(see figure M)
– Bring the power tool into the working position.
– Turn the saw table
lever 9 must be felt to engage in the detent.
Checking:
The angle indicator 10 must be in alignment with
the 0° mark of the scale 12.
Adjusting:
– Loosen the screw
screwdriver provided and align the angle
indicator along the 0° mark.
– Retighten the screw again.
Aligning the Angle Indicator (Vertically1
(see figure N)
– Bring the power tool into the working position.
– Turn the saw table
lever 9 must be felt to engage in the detent.
Checking:
The angle indicator 38 must be in alignment with
the 0° mark of the scale 41.
Adjusting:
– Loosen the screw
screwdriver and align the angle indicator along
the 0° mark.
– Afterwards, check to ensure that the
adjustment made is correct for the 45° mark.
– Retighten the screw again.
6 to the 0° detent 11. The
40 with the Phillips
6 to the 0° detent 11. The
42 with the Phillips

Aligning the Fence

– Bring the machine into the transport position.
– Turn the saw table
lever 9 must be felt to engage in the detent.
Checking: (see figure 01)
– Set an angle gauge to 90° and place it on the
saw table 6 between the fence 5 and the saw
blade 33.
The leg of the angle gauge must be flush with the
fence over the complete length.
Adjusting: (see figure 02)
– Loosen all Allen screws
– Turn the fence
over the complete length.
– Retighten the screws again.
Setting the Standard Bevel Angle 0°
(Vertical1
– Bring the machine into the transport position.
– Turn the saw table
Checking: (see figure P1)
– Set an angle gauge to 90° and place it on the
saw table 6.
The leg of the angle gauge must be flush with the
saw blade 33 over the complete length.
Adjusting: (see figure P2)
– Loosen the clamping lever
– Loosen the lock nut of the stop screw
a commercial box-end or open-end spanner
(size 13 mm).
– Screw the stop screw in or out until the leg of
the angle gauge is flush with the saw blade
over the complete length.
– Retighten the clamping lever
– Afterwards, retighten the lock nut of the stop
screw 25 again.
In case the angle indicator 38 is not in a line with
the 0° mark of the scale 41 after the adjustment,
loosen the screw 42 using a commercial Phillips
screwdriver and align the angle indicator along the
0° mark.
51
6 to the 0° detent 11. The
28.
5 until the angle gauge is flush
6 until it engages at 0°.
19.
19 again.
25 using