Table of Contents
Advertisement
12. Note: During steps 11 and 12, you will "sew"the lower
edge of the Netting(20) to the V-rings on the bed using
the Cords(23).
Locate the V-ring closest to the door. Thread one end
of a Cord(23) through the lower edge of the Netting(20)
above the V-ring and then thread the Cord through the
V-ring. Tie the Netting to the V-ring, by making a double
knot in the Cord.
13. Thread the Cord(23) through the lower edge of the
Netting(19) halfway between the first V-ring and
the V-ring to the left, and then thread the Cord
through the V-ring to the left. Repeat this
procedure until the entire Cord is threaded through
the Netting and the V-rings as shown. Keep the
Cord taut. Tie the end of the Cord to the last V-ring
that it reaches.
Tie a second Cord(not shown)to the last V-ring
reached by the first Cord. Thread the second Cord
through the Netting(20) and the V-ring as
described above. Repeat this procedure with the
remaining Cords until the last Cord reaches the
first Cord. (Note: The last Cord may overlap the
first Cord.) Make sure that the Netting is sewn to
every V-ring on the trampoline bed; the Netting
below the door must also be sewn to the V-rings.
14. Using the included plastic tie,attach the Safety
Placard(21)to the Netting(20)near the door as
shown.
The trampoline/enclosure is now fully assembled.Make
sure that all parts are securely attached. Familiarize
yourself and all users of the trampoline/enclosure with
the safety precautions, use and instructional materials,
and care and maintenance instructions in this manual
before using.
Disassembly
To disassemble the trampoline/enclosure,follow assembly steps 1 through 13 in reverse order.
Do not attempt to disassemble any trampoline frame components before the springs and the bed
have been removed.
Use gloves to protect your hands from pinch points during disassembly.
12
13
23
14
20
20
23
20
20
21
Advertisement
Table of Contents
