Assembly - LIFESTYLER Bazoongi User Manual

ASSEMBLY

IMPORTANT ASSEMBLY INFORMATION
• A Phillips Head screw driver is needed to
assemble trampoline/enclosure. However, a
screwdriver is not provided.
• Assembly requires two or three persons. Keep
children away from the trampoline/enclosure
until it is fully assembled.
• Use gloves to protect your hands from pinch
points during assembly.
• The assembly steps refer to parts by their descrip-
tions and key numbers (see the PART LIST on
page 22). If a part is missing, see ORDERING
REPLACEMENT PARTS on page 22.
TRAMPOLINE/ENCLOSURE PLACEMENT
1. Place the trampoline/enclosure on a level surface
before use.
2. Adequate overhead clearance is essential. A
minimum of 7.3 m (24 ft.) from ground level is
1. Make sure you understand the information in
the box at the top of this page before you
begin assembling the trampoline.
Lay Top Tube (1,2) and ( 3 ) on the ground as
shown.
Make sure there are a T-Socket (4?A Marking) on
Top Tube (3,A Marking) and a Enclosure Socket
(5, B Marking) on Top Tube (1, B Marking). Insert
the smaller end of Top Tube (3, A Marking) into
Socket (6) on Top Tube (2,B Marking).
Insert the smaller end of Top Tube (2, B Marking)
into Enclosure Socket (5, B Marking).
Insert a Center (9) into the Leg (8, which is shorter
than Leg (7).), slide a second (7, A Marking) onto
the base. Tighten a Self-tapping Screw(19) into the
small hole in the Leg (7, 8). Insert the Leg(7?A
Marking) into the Socket(4, A Marking) and insert
the Leg(8, B Marking) into Enclosure Socket (5, B Marking).
Step on the Top Rail (1, 2),lift the leg, and insert the leg into the Socket (4) and Enclosure Socket (5).
You have now assembled one leg section. Repeat this step to assemble three more leg sections.
recommended. Provide clearance for wires,
tree limbs, and other possible hazards.
Lateral clearance is also essential. Place the
trampoline/enclosure away from walls, structures,
fences, and other play areas. Maintain a clear
space on all sides of the trampoline/enclosure.
3. Use the trampoline/enclosure in a well-lighted
area. Artificial illumination may be required for
indoor or shady areas.
4. Secure the trampoline/enclosure against
unauthorized and unsupervised use.
5. Remove any obstructions from beneath the
trampoline/enclosure.
6. The owner and supervisors of the trampoline
are responsible to make all users aware of
practices specified in this manual.
7. The trampoline/enclosure is only to be used
as an enclosure for a round trampoline.
1
19
2(B Marking)
B marking
A marking
1
5(B Marking)
15
19
9
7(A Marking)
8(B Marking)
4(A Marking)
3(A Marking)
6