LIFESTYLER Bazoongi User Manual page 18

7. Using the included plastic tie, attach the Safety
Placard (21) to the frame near the point where
jumpers will climb onto and off the trampoline.
The trampoline is now fully assembled. Make
sure that all parts are securely attached.
Familiarize yourself and all users of the tram-
poline with the safety precautions, use and
instructional materials, and care and mainte-
nance instructions in this manual before using
the trampoline.
8. Lay a Straight Tube(15) and a Top Tube (16) with
Plastic Cap on the ground.
Make sure that the Straight Tube (15) is oriented
so the small holes are in the position shown.
Slide a Foam Sleeve (18) onto each of the tubes;
note that the ends of the Straight Tube (15) should
not be covered.
Insert the Straight Tube (15) into the Top Tube(16).
Tighten a Self-tapping Screw (19) into the small hole
in the Tube (15,16).
Assemble the remaining Straight Tubes (15), Top
Tubes (16) and Foam Sleeves (18) in the same way.
9. Insert the end of Pole (15,16) into the hole of
Enclosure Socket (5).
Make sure that the straight tubes (15) are oriented so
the small holes are in the position shown. Tighten a Self-
tapping screw (19) into the small hole in the Enclosure
Socket (5).
Attach the other three Poles (15,16) in the same way.
See inset drawing.
7
8
15
15
18
19
Tighten Self-tapping Screw
Into Small Hole
9
16
15
5
Insert the Completed Pole(15,16)into
the hole of Enclosure Socket(5).
19
18
Frame
21
18
16
18
Small Hole
18
Plastic Cap
(22)
16
11
10
16
15
5
Plastic Cap
(22)