Passion Veneto Owner's Manual page 7

6. Press the Pump 1 button a third time to turn Pump 1 off. A built-
in timer automatically turns Pump 1 off after 20 minutes, unless
the pump manually has been deactivated first.
7. Press the Pump 2 button
after 3 minutes repeat same priming procedure of step 3
above for Pump 1. Check and adjust the water and airflow of
every jet from Pump 2 if necessary.
8. Press the Pump 2 button again. You should hear the second
pump turn on a higher speed and the icon swirl faster.
9. Press the Pump 2 button a third time to turn off Pump 2. A built-
in timer automatically turns Pump 2 off after 20 minutes, unless
the pump manually has been deactivated first.
10. Press the Light button
this button again to cycle through the five colors (red, blue,
green, white, and yellow). Once a desired color is found,
pressing this button again stays on this color.
11. Press the Light button again to turn the spa Light off. A built-in
timer automatically turns the spa Light off after two hours,
unless the spa Light manually has been deactivated first.
12. Press the Next Page button
13. Press the Blower button
equipped). Check that air goes to the air jets on the bottom of
each seat.
14. Press the Blower button again to turn the Blower off. A built-in
timer automatically turns the Blower off after 20 minutes.
Note: When temperature limits allow, a circulation pump and
ozone generator run continuously to help keep your water clean.
. If Pump 2 has not primed
to turn the spa Light on. Press
.
to turn on the air blower (if
7