Passion Veneto Owner's Manual page 6

1. Turn on the breaker and test the operation of the Ground-Fault
Circuit Interrupter (GFCI) breaker by pushing the small button.
This should automatically trip the spa's circuit breaker.
DANGER: If this breaker does not trip, immediately call your
Only if pushing this button successfully trips this circuit breaker
should you reset this breaker and proceed to the next step.
2. Go to the topside control
panel and look at the
display. The system goes
through a startup
sequence after which the
circulation pump starts
and the panel displays
the current water
temperature.
3. Press the Pump 1 button
pump turn on, see water circulating in the spa, and see the
icon swirl on the display.
4. Press the Pump 1 button again. You should hear the first pump
turn on a higher speed and the icon swirl faster.
Caution: If water does not flow from the jets after 2 minutes,
5. If the water is running smoothly through the lines, open the air
control valve and you should see an increase in jet pressure.
Check and adjust the water/airflow of every jet if necessary.
Each jet in your spa can be adjusted for massage intensity and
directional flow. Turn the outer jet dial counterclockwise to
increase the water volume and clockwise to turn it off. Pivot
the angle of a jet to achieve an optimal massage.
Adding an air mixture intensifies the level of your massage. Turn
the air control valve counterclockwise to increase the air
mixture and clockwise to turn it off.
To minimize heat loss, close the air control valve when your spa
is not in use.
electrician. Do not use your spa!
turn power off at the main panel and bleed air
from the system (see page 17). Turn power on
again. Sometimes momentarily turning a pump
off/on will prime it. Only do this four times.
. You should hear the first
6