Lubricate O-Rings; Battery Charger - Husqvarna Pressure Washer Operator's Manual

Lubricate O-Rings

Lubrication of o-rings is extremely important for installation
and operation. The use of a lubricant (petroleum or synthetic
grease) during assembly helps seat o-rings properly and
provides an improved seal. It also helps protect the o-ring
from damage by abrasion, pinching or cutting and extends
the life of the o-ring.
NOTICE ALWAYS apply a small amount of lubricant on
o-rings prior to assembling the garden hose to the pump
inlet (A), high pressure hose to pump outlet (B), high
pressure hose (C), nozzle extension (D), and spray gun (E).
Lubricate all connections shown below, following these
instructions:
1. Inspect and clean connecting surfaces prior to
lubrication and assembly.
2. Use lubricants sparingly during assembly; a light film is
all that is required.
3. Use a small brush or cotton swab to apply grease
directly to o-rings where they are not accessible (QC
fitting, M22 fitting).
10

Battery Charger

Use battery float charger jack to keep the starting battery
charged and ready for use. Battery charging should be done
in a dry location, such as inside a garage.
1. Plug charger into unit's "Battery Float Charger" jack,
which is located next to the start switch. Plug battery
charger into a 120 Volt AC wall receptacle.
2. Unplug charger from unit and wall outlet when pressure
washer is being started and while it is in operation.
3. Keep this charger plugged in when pressure washer is
not in use to prolong battery life. The charger has a
built in float equalizer and will not overcharge the
battery, even when plugged in for an extended period of
time.
NOTICE See Battery Maintenance for additional information.
E
B
D
A
C
www.usa.husqvarna.com