Quick Spin Test Mode - Samsung WF42H5700A Series Technical Information

ALIGNMENT AND ADJUSTMENTS
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.

Quick Spin Test Mode

Delay End + Temp
While it is not in Hold Speed Mode
Definition of Quick Spin Test Mode:
- Quick Spin Test Mode is to do Spin Check. (High RPM)
How to Enter:
- During Service Mode, press the Delay End and Temp Keys for 3 seconds to enter Quick Spin Test Mode.
- Cannot enter once the washing cycle has started.
Quick Spin Test Mode:
As it enters into the Quick Spin Test Mode, it starts spinning and reaches to its maximum RPM.
Once the Spin speed reaches the maximum RPM, the speed drops immediately.
To hold Quick Spin Test Mode (entering Hold Speed Mode), press the Start/Pause button. If the
Start/Pause button is pressed during Quick Spin Test Mode, it will stop accelerating and hold its
spinning speed for 10 minutes before going back to Quick Spin Test Mode.
Also, to cancel the hold and allow Quick Spin Test Mode to continue, press the Delay End and Temp
Keys for 3 seconds If you the Delay End and Temp Keys for 3 seconds when the washing machine is
not in Hold Speed Mode, Quick Spin Mode is exited and Service Mode is restored.
WARNING
Service Mode
Delay End + Temp
3 sec
While a cycle is not running
Quick Spin Test Mode Start/Pause
Delay End + Temp for 3sec or after 10 minutes
9
Hold Speed Mode