Quick Spin Test Mode - Samsung WA456 Series Technical Information

ALIGNMENT AND ADJUSTMENTS
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
Service Mode
Service Mode:
1. The washer must be on to go into the Service Mode.
2. The motor speed will be displayed when started (It displays 0 when the motor does not spin).
3. The present state of the machine will not be changed.
(i.e., the current cycle in progress will not be interrupted and only the display will change)
4. To exit Service Mode, press Delay Start and AquaJet
Keys for 3 second again, or Power Key.If no key is operated during Service Mode for 5 minutes,
the machine will return to normal user mode.

Quick Spin Test Mode

Definition of Quick Spin Test Mode:
- Quick Spin Test Mode is to do Spin Check. (High RPM)
How to Enter:
- During Service Mode, press the Delay Start and Eco Plus(WA456*)/Pre Soak(WA422*,WA400*)
Keys for 3 seconds to enter Quick Spin Test Mode.
- Cannot enter once the washing cycle has started.
Quick Spin Test Mode:
As it enters into the Quick Spin Test Mode, it starts spinning and reaches to its maximum RPM.
Once the Spin speed reaches the maximum RPM, the speed drops immediately.
To hold Quick Spin Test Mode (entering Hold Speed Mode), press the Start/Pause button. If the
Start/Pause button is pressed during Quick Spin Test Mode, it will stop accelerating and hold its
spinning speed for 10 minutes before going back to Quick Spin Test Mode.
Also, to cancel the hold and allow Quick Spin Test Mode to continue, press the Delay Start and Eco
Plus(WA456*)/Pre Soak(WA422*,WA400*) Keys together for 3 seconds.
If you hold down the Delay Start and Eco Plus(WA456*)/Pre Soak(WA422*,WA400*) keys for three
(3) seconds when the washing machine is not in Hold Speed Mode, Quick Spin Mode is exited and
Service Mode is restored.
WARNING
Delay Start and AquaJet (WA456*)/
Extra Rinse(WA422*/WA400*)
Delay Start + Eco Plus(WA456*)/
Delay Start + Eco Plus(WA456*)/ Pre Soak(WA422*,WA400*)
Pre Soak(WA422*,WA400*) 3 sec
While it is not in Hold Speed Mode While a cycle is not running
7
TM
(WA456*), Extra Rinse(WA422*/WA400*)
TM
Delay Start + Eco Plus(WA456*)/
Pre Soak(WA422*,WA400*) for 3 sec or
after 10 minutes