Smart Install Mode - Samsung WF42H5700A Series Technical Information

ALIGNMENT AND ADJUSTMENTS
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.

Smart Install Mode

Definition of Smart Install Mode:
- Smart Install Mode is the mode that confirm whether
normal set mode ends after setting has been done.
How to Enter:
- Under standby condition, Set the appointment time
to 17:00. If you push Start/Pause button for 7seconds,
you will enter Smart Install Mode.
Samrt Install Mode
- When entering Smart Install Mode, it will display "SC".
- Smart Install Mode has two Modes
Manual Mode : When you push Delay End button,
submode will be added.
Automatic Mode : Under the condition of "SC" or "OK"
being displayed, if you push Start/Pause button, it will change to automatic
mode till the end of inspection.
- The display and Test of various submodes are as follows :
SC:standby codition
1: Door Lock Test
2: Drain Pump Test1
3: Pre Valve Test
Co: Cold Valve Test
Ho: Hot Valve Test
6: Water shot Valve & Motor Tumble & Water Heater Test
7: Drain Pump Test2
8: Spin Test
9: Dry Heater & Dry Fan Test
10: Door Unlock Test
Ot(OK): Normal end
- If you push "Delay End+Start" simultaneously when displaying "SC", EEPROM will be read and
OK or nG will display.
- Ot(OK) : Smart Install ends normally.
nG : Smart Install ends abnormally or doesn't execute.
WARNING
Standby Condition
Set the appointment time to 17:00
Push Start/Pause button for
Smart Install Mode
15
7 seconds