Installation and Wiring
Using RS-422
When communicating via RS-422, connect the wiring as shown in FIG. 3.
AXC-
AXB-
232++
232++
FIG. 3 RS-422 wiring
Using RS-485
When communicating via RS-485, connect the wiring as shown in FIG. 4.
AXC-
AXB-
232++
232++
FIG. 4 RS-485 wiring
To enable RS-485, set jumper J2 to the ON position (refer to Setting the Internal
Jumpers on page 7).
Using Hardware Handshaking
When the controlled device requires hardware handshaking, connect the wiring as shown in FIG. 5.
AXC-232++
FIG. 5 Hardware handshaking wiring
Installing the AXC-232++ in a CardFrame:
1. Remove all static electricity by grounding yourself.
2. Hold the card by the tab end and slide the card into the frame, into one of the slots. Make sure
the card is correctly positioned in the guide slot.
3. Gently push the card in until it is firmly seated in the card connector slot. You do not have to
disconnect the power to the CardFrame when you install the card. When power is applied to
the card, the LEDs blink to indicate the connection.
6
GND
RX
TX
+12V
RX -
RX +
TX -
TX +
GND
RX
TX
+12V
RX -
RX +
TX -
TX +
1
2
CTS
RTS
CTS
3
RTS
4
GND
TX-
TX+
Device
RX-
RX+
Device
Device
AXC-232++ RS-232/422/485 Interface Card