Subscribe to Our Youtube Channel
Related Manuals for AMX AXC-INP8
Summary of Contents for AMX AXC-INP8
-
Page 1: Instruction Manual
AXC-INP8 Switch/Opto Voltage Input Card A x c es s C o n t ro l C a rd s... - Page 2 This warranty extends only to products purchased directly from AMX Corporation or an Authorized AMX Dealer. AMX Corporation is not liable for any damages caused by its products or for the failure of its products to perform. This includes any lost profits, lost savings, incidental damages, or consequential damages. AMX Corporation is not liable for any claim made by a third party or by an AMX Dealer for a third party.
-
Page 3: Table Of Contents
Table of Contents Product Information ...1 Input Mode Selections ...3 Input Mode Selection Jumpers... 3 Voltage Mode ... 3 Switch Mode... 3 AXC-INP8 Eight Switch/Opto-Logic Voltage Input Card Table of Contents... - Page 4 Table of Contents AXC-INP8 Eight Switch/Opto-Logic Voltage Input Card...
-
Page 5: Product Information
(high/low) changes. Input signals may originate from tape transports, limit switches, foot mats, or the AMX PCS Power Current Sensor. Each input may be set for either switch closure (SW) or voltage operation (VO), allowing a combination of either application on the same AXC-INP8 card. - Page 6 Product Information AXC-INP8 Eight Switch/Opto-Logic Voltage Input Card...
-
Page 7: Switch Mode
2.5 - 24 volts. The required current is 0.6 mA at 5 V or 1.6 mA at 12 V. Switch Mode Switch Mode is used to sense switch or relay contact closures. Inputs using the AMX PCS Power Current Sensor will use this setting. Refer to the PCS and PCS2 Power Current Sensors instruction manual for additional information. - Page 8 AMX reserves the right to alter specifications without notice at any time. brussels • dallas • los angeles • mexico city • philadelphia • shanghai • singapore • tampa • toronto • york 3000 research drive, richardson, TX 75082 USA • 469.624.8000 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993...
Need help?
Do you have a question about the AXC-INP8 and is the answer not in the manual?
Questions and answers