Machine Operation; Pre-Run Machine Inspection; Equipment Set-Up; Priming The Pump - Century 400 Ninja 411-222MO Operating Instructions Manual

Portable extractor

Hide thumbs

Table Of Contents

Table of Contents

PRE-RUN INSPECTION

1. Check all fittings and connectors for proper

assembly.

2. Check all hoses for leaks. Repair or replace

any damaged hoses.

3. Check power cord(s) for any damage. If

damaged, replace.

EQUIPMENT SET-UP

1. Plug power cord from machine into properly

grounded wall outlet.

2. Turn vacuum motor switch on and off to

make sure there is electrical power at

machine.

3. Connect vac hose to machine. Slide the

swivel cuff over the outlet on the tank.

4. Connect the hose to your machine and

wand. Pull back the knurled collar on the

quick disconnect coupler and push onto the

connection on the chassis. To avoid leaks,

check to be that a positive connection was

made.

5. Using a clean container, fill the solution tank

with clean hot water. Mix in a non-foaming

cleaning concentrate for use in hot water

extraction machines, following the

manufacture's instructions printed on

container.

NOTE: When using a powder cleaner, pre-mix

with hot water in a clean container before adding

to the solution tank.

6. Turn pump and vacuum switch(s) to the on

position.

7. Start cleaning.

PRIMING THE PUMP [SELF PRIMING VALVE]

1. Turn pump and both vacuums on.

2. Press lever (located above the accessory

connection; front of machine) toward

machine.

3. Do this for 30 seconds or until there is a

steady flow of water flowing through the sight

tube (located on right side of recovery tank.)

EMPTYING AND CLEANING

large particles that may damage vacuum(s)

as well as allow liquid into the vacuum

motor(s) without activating the float shutoff.

1. Before proceeding, make certain that the

nozzle is functioning properly.

a. To check, hold the wand about one foot

b. If the nozzle is not showing a full spray

2. Normally, chemical is applied on the push

stroke of the wand when cleaning.

Vacuuming is done on the pull stroke. For

heavily soiled carpets the wand may be used

in a scrubbing manner, applying chemical in

both the push and pull stroke.

3. When cleaning, keep the working opening

(wand mouth) flat on the surface being

cleaned. Keep the wand moving when the

valve is open.

4. The shutoff float inside the vacuum tank will

impede the vacuum flow when the vacuum

tank is full.

When this occurs, empty the vacuum tank by

opening the dump valve and dispose of the

waste in a proper manner.

5. Once the vacuum tank has been emptied,

you may once again proceed with cleaning

NINJA 86038590 03/26/07