Kyocera ECOSYS P6030cdn Operation Manual page 167

>>Low Power Timer
005 min.
>>Sleep Timer
015 min.
Using the Operation Panel
3
Press  or  to increase or decrease the value at the blinking cursor
and set the desired time. The time must be set between 005 and 495
seconds, in 5-second increments. Use  and  to move the cursor
right and left.
4
Press [OK].
5
Press [MENU]. The display returns to Ready.
Low Power Timer (Low Power Mode timer timeout time)
You can adjust the length of time the printer waits before entering Low
Power Mode in the absence of a print job.
The printer reverts to normal operation mode when the printer receives a
print job or [GO] is pressed on the operation panel. The default time is
1 minute.
1
After entering the administrator ID and password, press  or 
repeatedly until >>Low Power Timer appears.
2
To change the timeout time, press [OK]. A blinking cursor (_)
appears.
3
Press  or  to increase or decrease the value at the blinking cursor
and set the desired time. The timer can be set between 1 and 60 min.
Use  and  to move the cursor right and left.
4
Press [OK].
5
Press [MENU]. The display returns to Ready.
Sleep Timer (Sleep timer timeout time)
You can adjust the length of time the printer waits before entering Auto
Sleep in the absence of data.
The printer reverts to normal operation mode when the printer receives a
print job or [GO] is pressed on the operation panel. The default time is
15 minutes.
Note Color calibration is automatically executed before the
printer reverts to normal operation mode.
1
After entering the administrator ID and password, press  or 
repeatedly until >>Sleep Timer appears.
2
To change the timeout time, press [OK]. A blinking cursor (_)
appears.
3
Press  or  to increase or decrease the value at the blinking cursor
and set the desired time. The timer can be set between 1 and 60 min
(for Europe) or 1 and 240 min (except for Europe). Use  and  to
move the cursor right and left.
4
Press [OK].
5
Press [MENU]. The display returns to Ready.
6-71