Subwoofer Connections - Infinity MODULUS Owner's Manual

S
UBWOOFER
If your receiver/processor does not have subwoofer outputs for
the left and right channels or an LFE output:
RECEIVER/AMPLIFIER
Front Speaker Output
Line Level Input
In Out
Select
L L
Speaker
R R
Line
+ +
Ð Ð
Right
Left
+ +
Ð Ð
In Out
SPEAKER LEVEL
Caution: For continued protection against risk of fire,
replace only with same type fuse and rating.
Attention: Utiliser un fusible de rechange
de meme type et calibre.
3A 120VAC 60Hz 3A 250V
ANSI/UL-1492
LR106476
WARNING: SHOCK HAZARD • DO NOT OPEN
NO USER SERVICEABLE PARTS INSIDE
AVIS: RISQUE DE CHOC ELECTRONIQUE
NE PAS OUVRIR
• Set Input Selector to "Speaker."
• Set Low-Pass Filter to "On. "
BLACK =
1. LOOSEN TERMINALS
2.
INSERT BARE END;
TIGHTEN TERMINALS
NO STRIPE =
MODULUS
8
C
ONNECTIONS
Low-Pass
Filter Phase R.A.B.O.S.
o
180
On On
o
Off 0 Off
Freq.
Level
Width
POWER
On
Off
+
RED =
–
– +
STRIPE =
If your receiver/processor has subwoofer
outputs for the left and right channels:
RECEIVER/PROCESSOR
Line Level Input
In Out
Select
L L
Speaker
R R
Line
+ +
Ð Ð
Right
Left
+ Ð Ð +
In Out
SPEAKER LEVEL
Caution: For continued protection against risk of fire,
replace only with same type fuse and rating.
Attention: Utiliser un fusible de rechange
de meme type et calibre.
3A 120VAC 60Hz 3A 250V POWER
On
Off
ANSI/UL-1492
LR106476
WARNING: SHOCK HAZARD • DO NOT OPEN
NO USER SERVICEABLE PARTS INSIDE
AVIS: RISQUE DE CHOC ELECTRONIQUE
NE PAS OUVRIR
If you have a Dolby* Digital or DTS
low-frequency-effect (LFE) output:
SUBWOOFER OR
LFE OUTPUT
Line Level Input
In Out
Select
L
L
Speaker
R
Line
R
+ – – +
Right
Left
+ – – +
In Out
SPEAKER LEVEL
Caution: For continued protection against risk of fire,
replace only with same type fuse and rating.
Attention: Utiliser un fusible de rechange
de meme type et calibre.
3A 120VAC 60Hz 3A 250V POWER
On
Off
ANSI/UL-1492
LR106476
WARNING: SHOCK HAZARD • DO NOT OPEN
NO USER SERVICEABLE PARTS INSIDE
AVIS: RISQUE DE CHOC ELECTRONIQUE
NE PAS OUVRIR
Note: Some receivers have a single subwoofer output.
In that case, it is recommended that you use a Y connector
(not included) to maximize performance.
Low-Pass
R.A.B.O.S.
Filter Phase
• Set Input Selector
o
On 180 On
to "Line. "
Off o Off
0
• Set Low-Pass
Filter to "On. "
Freq.
Level
Width
® receiver/processor with a
Low-Pass
• Set Input Selector
Filter Phase
R.A.B.O.S.
° to "Line. "
On 180 On
• Set Low-Pass
°
Off 0 Off
Filter to "Off" .
Freq.
Level
Width