Switching The Dimmer Setting; Adjusting The Brightness; Setting The Rear Output And Subwoofer Output; Setting The Internal Power Amplifier - Pioneer Premier DEH-P710BT Operation Manual

Section
11 Initial Settings

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the car's headlights are turned on. You
can turn the dimmer on or off.
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 48.
2 Use MULTI-CONTROL to select Dimmer
in the initial setting menu.
3 Press MULTI-CONTROL to turn dimmer
on.
# To turn dimmer off, press MULTI-CONTROL
again.

Adjusting the brightness

You can adjust the display brightness.
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 48.
2 Use MULTI-CONTROL to select
Brightness in the initial setting menu.
3 Push MULTI-CONTROL left or right to
adjust the brightness level.
0 to 15 is displayed as the level is increased or
decreased.
# When dimmer is functioning, the brightness
level can be adjusted 0 to 10.
Setting the rear output and
subwoofer output
This unit's rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (Rear SP :F.Range) or subwoo-
fer (Rear SP :S/W) connection. If you switch
the rear output setting to Rear SP :S/W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (Rear SP :F.Range).
50
En
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 48.
2 Use MULTI-CONTROL to select
S/W control in the initial setting menu.
3 Press MULTI-CONTROL to switch the
rear output setting.
Pressing MULTI-CONTROL will switch be-
tween Rear SP :F.Range (full-range speaker)
and Rear SP :S/W (subwoofer) and that status
will be displayed.
# When no subwoofer is connected to the rear
output, select Rear SP :F.Range (full-range speak-
er).
# When a subwoofer is connected to the rear
output, select Rear SP :S/W (subwoofer).
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
45).
! If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Setting the internal power
amplifier
This unit features high power amplifier. How-
ever, in particular system, external amplifiers
are used instead of internal amplifier. If you
use external amplifiers in order to establish a
multi-amp system, and don't use internal am-
plifier, it is recommended to turn off the inter-
nal amplifier. Turning off internal amplifier
reduces the noise that comes from the beha-
vior of internal amplifier.
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 48.