Section 2: Set-Up Adjustments; Screen Voltage Adjustment (Coarse Adjustment); Screen (G2) Adjustment (Fine Adjustment); Deflection Yoke Tilt Adjustment - Sony KP-53V100 Service Manual

2-1. SCREEN VOLTAGE ADJUSTMENT
(COARSE ADJUSTMENT)
1. Select a video input with no signal applied (the screen must be black,
and the room must be as dark as possible. You may use a heavy
blanket over the screen to block out ambient light).
2. Select picture mode "Personal 1" or "Personal 2", and set
BRIGHTNESS to 50% and PICTURE to minimum.
3. Turn the green SCREEN control on the focus block all the way to the
left and then gradually turn it to the right until the retrace line is barely
visible.
4. Gradually turn the control to the left until the retrace line just
disappears.
5. Repeat steps 1 through 4 for the red and blue CRTs.
R
R
FOCUS block
2-2. SCREEN (G2) ADJUSTMENT
(FINE ADJUSTMENT)
If the jig described below is available, it is recommended that the G2
Fine Mode Adjustment be performed to set the screen controls to their
optimal condition. If desired, you can build the jig illustrated below,
using 3-watt resistors. Please note that if the proper voltage is not
obtained with the listed resistor's values, then increase or decrease one
of the values in the resistor network to obtain the correct voltage.
1. Select VIDEO-1 mode no signal applied (the screen must be black).
2. Connect the G2 JIG.
3. Switch on the JIG.
4. Connect an oscilloscope to the TP701(KR), TP732(KG) and
TP761(KB) of CR board, CG board and CB board.
5. Adjust red, green, and blue screen voltage to 168-172V with SCREEN
controls on the focus block, as shown below.
G2 JIG
3.3k
200V
170V +/- 2V
GND

SECTION 2: SET-UP ADJUSTMENTS

G B
SCREEN
G B
FOCUS
K
SW
5.6k 5.6k 5.6k
GND
pedestal level

2-3. DEFLECTION YOKE TILT ADJUSTMENT

1. Display a cross-hatch pattern
2. Enter the service mode.
3. Cover the red and blue CRT lenses with lens caps to allow only green
to show (or use the method shown in the note below for turning off
the CRTs individually without using lens caps).
4. Loosen the green CRT's deflection yoke set screw and align the tilt
of the deflection yoke so that the horizontal bars at the center of the
cross-hatch pattern are parallel to the top and bottom edges of the
screen.
5. After aligning the deflection yoke fasten it securely, making sure it is
fully forward on the neck of the CRT.
6. The tilt of the deflection yoke for red and blue are aligned the same
way as the green CRT.
Cover the green and blue CRT lenses with lens caps (or use the
method shown in the note below for turning off the CRTs individually
without using lens caps), then repeat steps 4 and 5 for the red CRT.
Cover the green and red CRT lenses with lens caps (or use the
method shown in the note below for turning off the CRTs individually
without using lens caps), then repeat steps 4 and 5 for the blue CRT.
Note: If lens caps are unavailable, you can cut off the unnecessary color
beams in the service mode by individually changing the data from "1" to
"0" in category VPNT, item 28 RON (red), item 29 GON (green), or item
30 BON (blue).
2-pole magnet
— 15 —
4-pole magnet
Deflection yoke
Anode cap
KP-53V100