Installing The Camera - Ikelite POWERSHOT G11 Instruction Manual

Opening the Housing
Lid Snaps have a Lock.
To open housing, push Lid Snap
Lock forward and lift as shown.
Keep pressure on the Lid Snap so
it does not fly open quickly.
Some lid snaps have a lot of
spring tension once they go over
center, so keep a firm grip on the lid snap.
Lid Snaps may be opened one at a time.

Installing the Camera

1. Pull out on each housing control until it stops. This will get the controls
out of the way for installation of the camera.
2. Remove the back from the housing.
3. The mounting tray for the camera is secured to the housing back.
Position the camera on the tray.
4. Slide the housing Hotshoe Connector into the Camera Hothoe Mount
- page 8, diagram A. Slide the connector forward until it stops. This
should be done before the camera is secured with the mounting bolt
- page 8, diagram B.
Note: If you are using an EV Controller and NOT hard-wiring your strobes
directly to the housing, leave the housing hotshoe disconnected from the
camera. You will also need to install the Flash Deflector (supplied) over
the back of the housing port to block and deflect the camera flash to the
EV controller.
Caution:
Do not remove the External Strobe Connector Waterproof Cap - page 8,
diagram A, unless an external sync cord is going to be plugged in. Do not
remove the Waterproof Cap or Sync Cord underwater.
Push Forward
Lift
7
Lid Snap Lock