Installing The Snap-On Shroud And Screen Cover - Audiovox VODEXL10 Installation Manual

10.1” overhead led backlit lcd monitor with dvd player

Hide thumbs Also See for VODEXL10:

Table of Contents

INSTALLING THE SNAP-ON SHROUD AND SCREEN COVER

Installing the Shroud

*NOTE: Work on a soft surface to avoid damaging the plastic.

Remove the double sided tape backing from the two strips on the

center section of the shroud.

Hook the shroud over the dome light and align the shroud tabs 1

with the eight openings around the rim of DVD player 2 .

Slide the shroud down until the shroud completely covers the

DVD player and that all eight tabs snap into all eight openings

around the DVD player 1 , 2 .

Apply pressure to the center section of the shroud in the area of

the double sided tape to ensure that the tape adheres.

Locate the

Slide Knob 3 in the hardware package and press it onto

the dome light switch 4 on the side of the DVD player.

Installing the Screen Cover

Open the LCD screen.

Hook the two tabs "A" (as shown) on the bottom edge of the

screen.

Carefully snap the opposite side over the hinge.

NOTE: If the wrong color Shroud and Screen Cover is installed, refer to

Appendix A of this manual for instructions to change the Shroud and

Screen Cover color.

Table of Contents

Table of Contents