Table of Contents
Advertisement
Video Input
Progressive
Interlaced video signal can be displayed in a progressive picture.
Off . . . .Not activated.
L1 . . . . .Select "L1" for a moving picture.
L2 . . . . .Select "L2" for a still picture.
Film
This function operates on 3-2 pulldown video sources. When this
function is "On", the projector reproduces pictures faithful to the
original film quality.
Reset
To reset the adjusted data, select Reset and press the SELECT
button. The confirmation box will appear and then select [Yes]. All
adjustments return to their previous figures.
Store
To store the adjusted data, select Store and press the SELECT
button. The confirmation box will appear and then select [Yes].
Stored data can be called up by selecting "Image" in the Image
Level Selection on page 34. If you change the Image level (p34)
without storing the adjusted data, the figures will go back to the
factory default settings.
Quit
Exit the Image Adjust Menu.
✔
Note:
• Progressive cannot be selected when 480p, 575p, 720p, 1035i, or 1080i is
selected in the AV System Menu (p33).
• Film can only be activated when selecting NTSC and 480i for Video System and
L1/ L2 for Progressive.
• 3-2 Pulldown or Telecine transfer is the process of changing images from film mode
to video mode. Film runs at 24 frames per second (fps), while NTSC television
signals (or video) have a run rate of 30fps, therefore the 24 fps film needs to be
speeded up to 30fps and transferred to get the best film-like images using a proper
field pattern.
36
Image Level Menu
Move the red frame pointer
to an image icon to be set
and then press the SELECT
button.
The confirmation
Store icon
box will appear
and then select
[Yes].
Advertisement
Table of Contents
