Table of Contents
Advertisement
Computer Input
Auto PC Adjustment
The Auto PC Adjustment function is provided to automatically adjust Fine sync, Total dots, Horizontal and Vertical positions
to conform to your computer. Auto PC Adjustment function can be operated as follows.
Direct Operation
The Auto PC Adjustment function can be operated directly by
pressing the AUTO PC button on the remote control.
Menu Operation
Auto PC adj.
1
Press the MENU button to display the On-Screen Menu.
Press the Point
to PC Adjust Menu icon.
2
Press the Point
Auto PC adj. icon and then press the SELECT button twice.
To store the adjusted parameters
The system parameters adjusted in the Auto PC Adjustment can
be stored in the projector. Once the parameters are stored, the
setting can be done just by selecting Mode in the PC System
Menu (p25). See "Store" on page 28.
✔
Note:
• Fine sync, Total dots and Picture Position of some computers can not be fully
adjusted with the Auto PC Adjustment function. When the image is not provided
properly, manual adjustments are required (p27, 28).
• The Auto PC Adjustment cannot be operated when 480i, 575i, 480p, 575p,
720p,1035i, or 1080i is selected in the PC System Menu (p25).
26
buttons to move the red frame pointer
7 8
d
button to move the red frame pointer to
Remote Control
PC Adjust Menu
Move the red frame pointer to
the Auto PC adj. icon and
press the SELECT button.
"Please wait ..." message
appears while Auto PC
Adjustment is in progress.
AUTO PC
button
PC Adjust Menu icon
Advertisement
Table of Contents
