Axis M1143-L Installation Manual page 13

AXIS M1143-L/M1144-L
Adjust image and focus
To focus AXIS M1143-L/M1144-L:
In the Focus Adjustment page in the camera's GUI, (Setup > Basic
1.
Setup > Focus), set the DC-Iris to Disabled and click Save.
2. Open the lid on the camera; adjust the zoom with the zoom puller in
the range 1-4 (1 > full wide; 4 > full tele).
3. Adjust the focus with the focus puller as required.
Note:
The lever tool can be used to adjust and tighten the zoom and
focus pullers.
From the Focus Adjustment page in the camera's GUI, set the DC-
4.
Iris to Enabled and click Save.
Adjust the Angle of Illumination slider in the camera's GUI. See
5.
note below.
Notes:
• The DC-Iris should always be disabled while focusing the camera. This opens the
iris to its maximum, which gives the smallest depth of field and thus the best
conditions for correct focusing. When the focus is set with this method it will
then be maintained in all light conditions
• The default zoom is set at 1. If the zoom is adjusted to a different value, move
the Angle of Illumination slider in the IR Light window (Camera Settings > IR
Light Settings > Edit) in the camera's GUI to the same value, for optimal IR
illumination.
Page 13
Zoom puller
Focus puller