Rear View - Macpower & Tytech Hydra LAN User Manual

Hydra LAN

1.3.3 Rear View

1. Smart fan
2. Security lock slot
3. Gigabit Ethernet port
4. Reset button
1
2
3
Smart Fan
The smart fan automatically regulates the fan speed according to the internal temperature.
It will start using low speed from 0-49 degrees, increase the speed every 5 degrees until
64 degrees and use full speed above 65 degrees Celsius.
Ethernet Port LED
The green LED on the left indicates the link connection and the LED on the right the speed.
green
Speed
10Mbps
Reset Button
Press this button for a software reset or when the Hydra LAN is powered up and ready,
press and hold this button for 5 seconds and then release it to reset all the settings back to
factory default. All user accounts and groups will be erased!
A/M Switch
A = System automatically starts again after a power outage.
M = System stays off and power has to be turned on manually after a power outage.
5. A/M switch
6. USB port (upstream)
7. Power receptacle (100-240V)
8. Power supply on/off switch
4 5 6
yellow green
1000Mbps 100Mbps
Page 3 / Chapter 1 - Introduction
8
7
yellow
User Guide