Table of Contents
Advertisement
CALLER ID UNIT TROUBLESHOOTING TABLE
SYMPTOM
•
•
The Caller ID
LCD panel is
blank
•
•
The Caller ID
•
LCD panel does
not show the
•
caller's name
and/or phone
number
•
•
"LINE
ERROR"
•
CALL INFO
Light
incorrectly
Flashing.
•
Difficulty
•
storing numbers
in memory.
•
No Data Sent
•
060512A-1
TROUBLESHOOTING
SOLUTION
Check the batteries for proper installation.
If the batteries are weak or dead, replace with new batteries
(alkaline batteries are recommended). Please refer to the
"Battery Installation" section of the user's manual for more
details.
Check the connection of the AC adaptor.
The Caller ID unit will not function until you have Caller ID
service provided by your local phone company. Call your
local phone company to have Caller ID installed on your
telephone line.
Check your telephone line connections. Refer to the section
"INSTALLATION" of the manual for details.
If you picked up the phone before the second ring, the caller
information will not be correctly received. If you have a
telephone answering device (TAD) connected with the unit, set
the TAD to answer after two rings or more.
If it is a blocked call or an out-of-area call, the caller's name
and/or phone number will not appear on the display. Please
refer to the "Receiving Caller ID Information" section of the
user's manual for more details.
On rare occasions, the Caller ID information sent by the
telephone company may have an error in the transmission.
This is not the fault of your Caller ID unit. It can only capture
and store the data that was received.
Make sure the telephone line cord is connected properly.
Make sure you are pressing the correct sequence of keys for
storing numbers.
If you are interrupted by a recorded announcement asking you
to hang up or by a loud buzzing noise, hang up and store the
number without lifting the handset.
On rare occasions, Caller ID information sent by the telephone
company may be too weak to be detected by the Caller ID.
This is not the fault of the Caller ID unit; it can only capture
and store the digital data that was received.
This message also appears when the Caller's local phone
company does not have Caller ID service available.
16
Advertisement
Table of Contents
