Operating Systems; Playback Of A Dvd - Fluid 8004576 Instruction Manual

Hdmi dvd player with usb

Hide thumbs

Table Of Contents

Table of Contents

Playback of a DVD

Unless otherwise stated, all operations described are based on Remote Control use.

1. Insert the AC plug (with the two blades) from the DVD player to a conveniently located

AC outlet. The POWER indicator on the front of the cabinet will light.

2. Connect the DVD player to the external TV (see illustrations on pages 11 to 13).

Turn on the TV and set to the corresponding input source.

3. Press the POWER button to turn the player on.

4. Press the

OPEN/CLOSE button to open the disc tray. Place the disc in the center of

tray with the label side face up. Close the tray by pressing the

The unit will start playback automatically.

5. Press the STOP button to stop playback. The player will remember the point where

disc was stopped. If you press the STOP button again, playback will start from this

point. To stop playback completely or to start again from the beginning, press the

STOP button twice.

Note: If the player will not be used for a long period of time, turn off the player by

unpluging the AC Cord from the wall outlet.

During playback, press either the

forward or backward at double (x2) speed to locate a specific section. Repeatedly press

these buttons and the speed will increase to x4, x8, x16, then resume normal playback. You

can also resume normal playback by pressing the

control or the

Note: This function is not available on all discs.

SKIP

While a disc is playing, you can skip forward or backward a chapter or track at any time by

PREV or

pressing the

For DVD Program

During DVD playback, press the PROG (program) button. The setting menu will appear on

the screen as shown in Fig. A.

•

Use the numeric and direction buttons to enter the desired title and chapter. The title is

entered in the second column and the chapter in the last column, as shown in Fig B.

•

Use the direction buttons to select and highlight the

the ENTER button to start program playback.

•

During editing, use the directions buttons to select and highlight"Clear Program" in the

menu. Press the ENTER button to clear the programs.

During playback, press the STOP button twice to cancel the program playback.

•