Motion Detection - LevelOne FCS-4000 User Manual

Motion Detection

When you click Motion Detection on the Advance mode menu, the Motion Detection setting menu appears.
There are three Motion Detection functions as sensors to set for different detecting zones. Each one has
Threshold and Sensitivity inputs which you can adjust to specific zone sequentially. Motion Detection
function can support to FTP, SMTP and Alarm output for capturing and sending images or starting alarm
output.
Click it On when you use the Motion Detection function and detecting zone appears for adjusting and
moving. The common setting options are displayed below. If you do not wish to use the Motion Detection
function, click it Off and press OK.
Motion Detection 1：Click it on for using Motion Detection 1 function as a sensor. You can adjust and move
the detecting zone by using mouse.
Motion Detection 2：Click it on for using Motion Detection 2 function as a sensor. You can adjust and move
the detecting zone by using mouse.
Motion Detection 3：Click it on for using Motion Detection 3 function as a sensor. You can adjust and move
the detecting zone by using mouse.
Threshold：You can use the tool bar to set up-limit value. When detecting zone signals are over setting
value, it would carry on assigned work.
Sensitivity：You can use the tool bar to set down-limit value. When detecting zone signals are over setting
value, it would carry on assigned work.
Carry out the following steps：
Click On to Motion Detection 1 choose one of eight orders.