Using 2 Or More Universal Temperature Controllers - Rinnai BC 70 2A Installation And User Manual

OPERATION WITH UNIVERSAL TEMPERATURE CONTROLLERS

Using 2 or more Universal Temperature Controllers

Switching the System 'ON':
The hot water system and all controllers can be switched ON
and OFF from any controller by pressing the 'ON/OFF'
Button as shown. When the system is turned ON the water
Temperature display will be lit. During normal operation the
system is left ON.
Using Hot Water
Ensure the system is switched 'ON'.
When the system is ON, the temperature
displays will be lit. Confirm that the transfer
on indicator is lit. If not press the TRANSFER
button once. This will transfer priority to this
controller which will then have control of the
water delivery temperature.
Select the desired temperature using the 'hot
water temp' buttons. The selected temperature
will be displayed on all controller monitors.
This is the water temperature which will be
supplied to all outlets.
Temperatures no higher than 50ºC should be able to be selected on controllers installed in bathrooms,
ensuites or toilets. This is to help reduce the risk of burns from hot water. If this is not the case, the
controllers have been incorrectly installed. CONTACT YOUR INSTALLER.
NOTE
Open the Hot Water Tap.
The appliance will be activated and the
'in use' indicator will light up.
Consumer safeguards: With the hot water tap open and a temperature of 43°C or higher selected, if the
temperature is decreased to below 43ºC, and then raised again the maximum available temperature will
be 43°C, in addition temperature 'priority' cannot be transferred between controllers.
NOTE
HOT COLD
- 11 -
- 6 -