Using 3 Deluxe Controllers And 1 Universal Controller - Rinnai BC 70 2A Installation And User Manual

OPERATION WITH DELUXE TEMPERATURE CONTROLLERS

Using 3 Deluxe Controllers and 1 Universal Controller

(Option available with Infinity and HD models)
When 4 Temperature Controllers are used, they must be one MC-70-2A (Kitchen), two BC-70-2A
(Bathrooms 1 & 2) and one MC-91-1A (Bathrooms 3)
AM
Transfer
0 0 0 0
Ho t wa ter
temp.
Clock Hour Min.
Sound Cooler Hotter
ON/OFF
Vol.
M C -7 0 - 1 A
Switching the System On
The hot water system can be switched on and off from any controller by pressing the 'ON/OFF'
button as shown. When the system is turned on, the monitors will be lit. During normal operation the
system is left on.
Setting the clock
See page 13 for details on set ting the clock.
Setting the Sound Volume
See page 16 for details on setting the sound volume.
Using Hot Water
The hot water delivery temperature can be controlled from the Kitchen Controller (MC-70-2A),
Bathroom Controller (BC-70-2A) or Universal Controller (MC-91-1A). See pages 16 to 17
for details on setting the hot water delivery temperature for the Kitchen and Bathroom
Controllers.
Shower Saver / Bath Fill Function
The 'Shower saver / Bath fill' function can only be used on Temperature Controller BC-70-2A.
See pages 17 to 19 for details on the 'Bath fill' function.
CHECK WATER TEMPERATURE BEFORE USE.
A parent should always check the temperature before a child is placed in contact with hot water
CAUTION
Consumer safeguards: With the hot water tap open and a temperature of 43°C or higher selected, if the
temperature is decreased to below 43ºC, and then raised again the maximum available temperature
will be 43°C, in addition temperature 'priority' cannot be transferred between controllers.
NOTE
Repeat the relevant procedures above for the third (Bathroom) controller.
- 26 -
- 22 -
.