Aux Sends Connectors; Aux Returns Connectors; 2-Track In/Out; Ctrl Room Output - Alto PM-12 DRAGONFLY User Manual

4.24 AUX SENDS Connectors

These 1/4" phone sockets are used to send out the signal from
the AUX bus to external devices such as effects.

4.25 AUX RETURNS Connectors

Use these stereo 1/4" phone sockets to return the sound of
an effect unit to the main mix. You can also use them as the
extra auxiliary inputs.

4.26 2-TRACK IN/OUT

- TAPE IN
Use the Tape input if you wish to listen to your mix from a Taper
Recorder or DAT. You can assign the signal coming from the
Taper Recorder either to a pair of studio monitor using the
control room assignment on the front panel or you can also
send the signal directly to the main mix.
- TAPE OUT
These RCA jacks will route the main mix into a tape recorder.

4.27 CTRL ROOM Output

These 1/4" phone sockets are used to send the control room
signal to the studio monitor speakers or a second set of PA.
4.28 SUBGROUPS OUT
Through the assignment control, the subgroup function allow
the operator to control groups of input channels in categories,
e.g. voices, drums, etc.. A more involved design called a matrix
allows the operator to provide multiple outputs through these
1/4" sockets and send each of the submixes to each of the
matrix output in variable degrees.
Typical uses of a matrix would be for patching the multitrack
recording and /or as a method of providing several monitor
mixes from the main mixer.
4.29 SUBGROUPS INSERT
These 1/4" phone sockets are insert points. They are used to
connect processors such as compressor, limiter, EQ etc..
When insert external processor into these jacks, the subgroup
stereo signal will be taken out, then returned to before subgroups
fader. Of course, these jacks used must be stereo (Tip Send/
Ring Return).
45
46
47
48
49
50
16
1 2
45
AUX SENDS
1 2
L L
46
R R
AUX RETUENS
2-TRACK IN/OUT
L
R
TAPE IN TAPE OUT
47
1 2
49
SUBGROUPS OUTPUT
1 2
50
SUBGROUPS INSERT
3 4
3 4
L L
R R
L
R
CTRL ROOM
48
3 4
3 4