Using The Alarm - iHome IP39 Instruction Manual

1. When no button is pressed for 2 sec. the timer is set. The lower part of the display will show current timer time.
2. Once the timer is set, it will start counting down over the set time period. Press the OFF Button at any time during timer
setting to cancel the timer.
3. When the set time is up, the buzzer alarm will sound until you press the OFF Button. Or press the quick timer/+1 min
button or timer 2 +5 min button to add additional time
Setting the Alarm
1. Press and hold the
2. Press the or Button to set the desired alarm time. Remember to set the correct AM or PM alarm time (A or P next
to alarm time indicates AM or PM alarm time).
3. Press the Alarm Button to select wake to sound source. Press the
iPod/iPhone, FM radio or buzzer. You cannot wake to aux audio device.
4. Press the Alarm Button (or no button within 10 seconds) to exit alarm setting mode. The alarm will be armed,
indicated by the alarm icon
Note: If iPod/iPhone or FM radio alarm sounds and iP39 detects no sound for 30 seconds (or if no iPod/iPhone is detected
or if AC power is unpluged), the buzzer will sound instead and iPod/iPhone will power down.
Review, Arming and Disarming Alarm (Turn Alarm Function On and Off)
To review the current alarm time and arm the alarm or to disarm the alarm, just press the
alarm is armed, the alarm icon and current alarm settings appear.
Resetting the Alarm to Come on the Next Day
When the alarm is sounding, press the Off Button to stop the alarm and cancel it. Press the
and reset it to come on the following day at the same time.
Sure Alarm
The iP39 has a sure alarm feature. If you have installed the backup battery, the buzzer alarm will still sound in the event of
power failure.
Timer Operation

Using the Alarm

Alarm Button until the alarm icon and alarm time flashes on the lower part of the display.
or Button to cycle through Alert Modes:
5
Alarm Button as needed. If the
Alarm Button to stop alarm