Setting The Alarms/ Reviewing, Arming And Disarming Alarms; Resetting The Alarm To Come On The Next Day - iHome iBT22 Instruction Manual

Setting the Alarms
1. By default, the unit selects the most recently linked Bluetooth device as your wake-to source. If no
Bluetooth device is detected, the iBT22 will automatically default to buzzer alarm. See page 8 to
setup your Bluetooth device.
Note: make sure you have an hour of audio on your Bluetooth device.
2. Press and hold the
beep sounds.
Press the – or + Button to set the alarm time. Remember to set the correct AM or PM time.
Button (or if no button is pressed within 10 seconds). Two beeps will confirm alarm time
3. Press the
and exit alarm setting mode. The alarm will be armed and the corresponding alarm icon will appear.
4. To set Alarm 2 just follow steps 2 - 3 using the
Reviewing, Arming and Disarming Alarms
1. Once an alarm is set, it is armed and the lower part of the display will show the alarm time. If both
alarms are armed, the earliest alarm time will show.
2. To arm/disarm the alarm, just press the associated alarm button to toggle it on or off. If the alarm is
armed, the related alarm icon will appear in the upper part of the

Resetting the Alarm to Come On the Next Day

When the alarm is sounding, press the
day.
Button until the current alarm time flashes in the lower part of the display and a
Button to stop alarm and reset it to come on the following
Using the
Button.
display.
6
iBT22