Removing The Monitor Stand - HP EliteDisplay Webcam Backlit LCD Monitor User Manual

Removing the Monitor Stand

You can remove the monitor panel from the stand to install the panel on a wall, a swing arm, or other
mounting fixture.
CAUTION:
power and signal cables are both disconnected. Also disconnect all USB cables connected to the
monitor.
1. Disconnect and remove the signal, power, and USB cables from the monitor.
2. Lay the monitor face down on a flat surface covered by a clean, dry cloth.
3. Pivot the stand 45 degrees clockwise and remove the lower right mounting screw from the back
of the monitor, then pivot the stand 45 degrees counter-clockwise and remove the lower left
mounting screw from the back of the monitor.
4. Remove the two upper mounting screws (1) then lift the stand off the monitor (2).
Before beginning to disassemble the monitor, be sure the monitor is turned off and the
Removing the Monitor Stand 15