Remove A Memory Card; Charge The Battery; Switch The Device On And Off - Nokia Mobile Phone User Manual

Remove a memory card

Important: Do not remove the memory card during
an operation when the card is being accessed. Doing so may
damage the memory card and the device, and corrupt data
stored on the card.
1. Press the power key briefly, and select
card > Yes.
2. Open the memory card slot cover.
3. Press the memory card gently to release it.
4. Pull the card out, and press OK.
5. Close the slot cover.

Charge the battery

Your battery has been partially charged at the factory. If the
device indicates a low charge, do the following:
1. Connect the charger to a wall outlet.
2. Connect the charger to
the device.
3. When the device
indicates a full charge,
disconnect the charger
from the device, then
from the wall outlet.
You can also charge the
battery with a USB data
cable connected to a
compatible computer.
10
1. Connect the USB data cable to a USB port of a computer
2. When the battery is fully charged, disconnect the USB data
USB charging efficiency varies significantly. In some cases, it
may take a very long time for charging to start and the device
to start functioning. You do not need to charge the battery
Remove memory
for a specific length of time, and you can use the device while
it is charging. If the battery is completely discharged, it may
take several minutes before the charging indicator appears
on the display or before any calls can be made.

Switch the device on and off

Press and hold the power key
to switch the device on and off.
A short press of this key ends
calls and applications.
If the device asks for a PIN
code, enter the PIN code, and
select OK.
If the device asks for the lock
code, enter the lock code, and
select OK. The factory setting
for the lock code is 12345.
To set the correct time zone,
time, and date, select the
country you are presently in,
then enter the local time and
date.
and to your device.
cable.
© 2009 Nokia. All rights reserved.