LightwaveRF JSJS LW100 Operation Manual

LightwaveRF JSJS LW100 Operation Manual

Lightwaverf jsjs lw100 handheld remote operation manual

Advertisement

LightwaveRF
connect
Handheld Remote
Operation Manual
Model No's: JSJS LW100
It is important to install this product in accordance
with the tting instructions below. Failure to do so
may render your guarantee void.
IMPORTANT: PLEASE RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE AND FOR GUIDANCE ON
THE ASSOCIATION OF REMOTE HANDSETS. FOR
HELP AND SETUP GUIDANCE PLEASE VISIT
www.lightwaverf.com

OVERVIEW:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JSJS LW100 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for LightwaveRF JSJS LW100

  • Page 1: Operation Manual

    LightwaveRF connect Handheld Remote Operation Manual Model No’s: JSJS LW100 It is important to install this product in accordance with the tting instructions below. Failure to do so may render your guarantee void. IMPORTANT: PLEASE RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE AND FOR GUIDANCE ON THE ASSOCIATION OF REMOTE HANDSETS.
  • Page 2 NOTE: If the RF range between the transmitter and receiver is too great to achieve reliable operation, the LightwaveRF Connect SIGNAL BOOSTER may be used in conjunction with this product to increase the signal strength over greater distances. Setting a Mood To set up a mood: 1.
  • Page 3 4. The handset LED will ash for 3 seconds. 5. The Handset will then send a ‘store mood’ code to all paired receivers, which will ash to show con rmation. OPERATION : 1) Linked to an ‘ON/OFF’ receiver (eg Room Control single, double or plug-in sockets): ‘ON’...
  • Page 4 2) Linked to a ‘Dimmer’ receiver (e.g. Room Control Single Dimmer or dimmable CFR): Lowering Dim Level 1. Make sure the light is switched on. 2. Hold down the ‘OFF’ button. 3. After 1 second the light will start to dim. 4.
  • Page 5 3. After 1 second the light will start to become brighter. 4. At the desired brightness release the ‘ON’ button. NOTE: If the ‘ON’ button is not released, the light level will increase until it stops at the maximum possible level of brightness.
  • Page 6 SPECIFICATION: RF frequency: 433.92 MHz Battery: 3V CR2032 lithium cell battery operated (included) Blue LED indicator Birmingham Science Park Aston Faraday Wharf Holt Street Birmingham B7 4BB Tel: 01902 500 562 Email: support@jsjsdesigns.com...

Table of Contents

Save PDF