Connecting A Dtv(Digital Tv); Connecting Digital Audio Output - Haier HL26R Owner's Manual

External Equipment Connections

Connecting a DTV(digital TV)

This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive
Digital signals from a digital set-top box or other digital external device, refer to the figure as shown below.
This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i).
How to connect
Use the TV`s COMPONENT , VGA or HDMI
jack for video connections, depending on
your set-top box connector. Then, make
the corresponding audio connections.
How to use
1. Turn on the digital set-top box. (Refer to the
owner`s manual for the digital set-top box.)
2. Use INPUT on the remote control to select
COMPONENT , VGA or HDMI source.
Signal COMPONENT
480i Yes
480p Yes
720p
Yes
1080i
Yes
1080p
Yes
Connecting a digital audio output
Send the TV`s audio to external audio equipment (stereo
system) via the Digital Audio Output (Optical) port.
How to connect
1. Connect one end of an optical cable to the TV Digital
Audio(Optical) Output port.
2. Connect the other end of the optical cable to the digital
audio (optical) input on the audio equipment.
See the external audio equipment instruction manual for
operation.
Note
When connecting with external audio equipments, such
as amplifers or speakers, please turn the TV speakers off.
Caution: Do not look into the optical output port.
Looking at the laser beam may damage
your vision.
12 TV LCD-TFT
HDMI
Yes
Yes
Yes
Yes
Yes
HDMI IN VGA IN
VGA AUDIO
VGA
2
1
DVI
L- - R
AUDIO
HDMI
COMPONENT IN
2
Y Pb Pr L-AUDIO- R
1
Y Pb Pr L-AUDIO- R
Digital Set-top Box
OPTICAL
OUT
L-AUDIO- R
VIDEO OUT
1
L-AUDIO- R VIDEO
Installation
OPTICAL
OUT