Key Assignment Mode - Kenwood PKT-23 Instruction Manual

This transceiver allows you to reprogram the PF-1 key (press/
hold) and PF-2 key (hold only) with any of the functions listed
in the table below. Explanations on the use of each function are
provided under "PROGRAMMABLE FUNCTIONS", on page 19.
Table Number
0
1
2
3
4
5
6
7
8
* To use this function, Repeater mode must be activated through
Programming Software.
To change the functions of the PF-1 and PF-2 keys:
1 With the transceiver power OFF, press and hold the Up and
PF-2 keys while turning the transceiver power ON.
Continue to hold the Power switch, Up key, and PF-2 key until
•
the LED indicator lights yellow and the transceiver announces
"Setup".
2 Release the Power switch, Up key, and PF-2 key.
• The transceiver announces "Table Zero".
3 Press the Up/Down keys to increment/ decrement the
number, to select the new key function.
• Table numbers and their corresponding functions are provided
in the table above.
• A voice announcement will inform you of the currently selected
Table number.
18

keY assIGnmenT moDe

None (no function)
Low Transmit Power
Monitor (PF-2 key hold default)
RX/TX Frequency Scan *
Scan (PF-1 key press default)
Squelch Off
Super Lock-C
Super Lock-P (PF-1 key hold default)
Tone Alert
Function Name