Table of Contents
Advertisement
WARNINGS
ATTENTION: RISQUE DE CHOC ELECTRIQUE – NE PAS OUVRIR
Read instructions
:
Do not remove covers
Power sources
:
Power cord routing
Grounding
:
WARNING: This equipment must be earthed.
Water and moisture
Ventilation
:
Heat and vibration
Servicing
:
Installation
:
MPS12 User Guide
Important Safety Instructions
- Read the following before proceeding:
CAUTION
Retain these safety and operating instructions for future reference. Adhere to
all warnings printed here and on the power supply unit. Follow the operating
instructions printed in this User Guide.
:
Operate the power supply unit with its covers correctly fitted. Refer any
service work on the power supply unit to competent technical personnel only.
Connect the power supply unit to a mains power supply only of the type
described in this User Guide and marked on the rear panel. Use only the
power cord with sealed mains plug appropriate for your local mains supply
as provided with the power supply unit. If the provided plug does not fit into
your outlet consult your service agent for assistance.
:
Route the power cord so that it is not likely to be walked on, stretched or
pinched by items placed upon or against it.
Do not defeat the grounding and polarisation means of the power cord plug.
Do not remove or tamper with the ground connection in the power cord.
:
To reduce the risk of fire or electric shock do not expose the power supply
unit to rain or moisture or use it in damp or wet conditions. Do not place
containers of liquid on it which might spill into any openings.
Do not obstruct the ventilation slots or position the power supply unit where
the air flow required for ventilation is impeded. If the power supply unit is to
be operated in a flightcase, ensure that it is constructed to allow adequate
ventilation.
:
Do not locate the power supply unit in a place subject to excessive heat or
direct sunlight as this could be a fire hazard. Locate the power supply unit
away from any equipment which produces heat or causes excessive
vibration.
Switch off the equipment and unplug the power cord immediately if it is
exposed to moisture, spilled liquid, objects fallen into the openings, the
power cord or plug become damaged, during lightening storms, or if smoke,
odour or noise is noticed. Refer servicing to qualified technical personnel
only.
Install the power supply unit in accordance with the instructions printed in this
User Guide. Do not connect the output of power supply unit to any other
equipment other than that specified by Allen & Heath.
3
Advertisement
Table of Contents
