3
1. Set plate
2. Holder
3. Screw
1
1. Handle latch
MAINTENANCE
5. Cutting repetitive lengths
001846
When cutting several pieces of stock to the same length,
1
ranging from 300 mm (11 - 3/4") to 400 mm (15 - 3/4"),
use of the set plate (optional accessory) will facilitate
more efficient operation. Install the set plate on the
holder (optional accessory) as shown in the figure.
Align the cutting line on your workpiece with either the
2
left or right side of the groove in the kerf board, and while
holding the workpiece from moving, move the set plate
flush against the end of the workpiece. Then secure the
set plate with the screw. When the set plate is not used,
loosen the screw and turn the set plate out of the way.
NOTE:
•
Use of the holder-rod assembly (optional accessory)
allows cutting repetitive lengths up to 2,200 mm (7.2 ft.)
approximately.
Carrying tool
002147
Make sure that the tool is unplugged. Secure the turn base at
right miter angle fully by means of the grip. Lower the handle
fully and lock it in the lowered position by turning the handle
latch to the locked position.
Carry the tool by holding both sides of the tool base as
002263
shown in the figure. If you remove the holders, dust bag, etc.,
you can carry the tool more easily.
CAUTION:
•
Always secure all moving portions before carrying the
tool.
•
Handle latch is for carrying and storage purposes only
and not for any cutting operations.
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
15